Text Insertion Setup - Dedicated Micros digital sprite 2 Setup Manual

VMD Test
Once the VMD Camera Settings have been configured, it is possible to test the
configuration.
Note: VMD must be enabled on the selected camera for the Walktest option to
selected.
When Walktest is selected, a prompt will be displayed. Follow the on-screen
instructions.
Press MENU / MODE key to start walktest
Press MENU / MODE key again to exit
If the settings are not satisfactory, adjust the settings and then carry out the
walktest again.
50 50

Text Insertion Setup

Note: This menu is only displayed if 'Text in Image' has been enabled in the
'Record Options' menu.
The Digital Sprite 2 supports the option to include text information, received
from a peripheral device, alongside the recorded video. The images can then
be searched on the text data, for review via web page.
Text Insertion Setup
Camera 1
Number of lines
Width of lines
Text colour
Text background
Camera
Each camera can be individually configured. Select the relevant camera by
pressing the corresponding camera key.
Number of Lines
This is the number of lines that will be displayed in live and replay using the
OSD (On-Screen Display) on the main monitor, along with the relevant images.
The default setting is 20 lines.
Width of Lines
This identifies the length of the lines that will be stored with the image. The
default setting is 50 characters, which is generally the full screen.
Text Colour
It is possible to select which colour the text from the peripheral serial device
will be displayed within the image. The options are; Black, White, Yellow,
Magenta, Red, Cyan and Green.
Text Background
A background can be applied to the text within the image. This is disabled by
default. The options available are; Black or White.
20
00 - 20
50 01 - 50
Black, White, Yellow, Magenta, Red,
White
Cyan, Green
Off
Off, White, Black