Activity Camera Setup - Dedicated Micros digital sprite 2 Setup Manual

Activity Camera Setup

Activity Camera Setup
Camera 1
Detection
Schedule activation
Sensitivity
Activity grid
Activity test
Actions
Advanced VMD zones
Camera
Each camera can be individually configured. Select the camera by pressing
the corresponding camera key.
Detection
Select whether activity detection is 'On' or 'Off' for the selected camera.
Note: If Detection is disabled, the sensitivity setting will still be used for Event
Search.
Schedule Activation
Each camera can be scheduled to be always enabled (24Hr Activation) or
individually activated during the day, night and at weekends.
Schedule Activation
Camera 01 Schedule Activation
Activation Type
Active
46 46
Off
Off, On
Edit
Indoor high, Indoor low, Outdoor high,
Indoor high
Outdoor low, Very Low
Setup
Walktest
Edit
Disabled Disabled, Enabled/Edit
Schedule Activation
24 Hour Activation
Day Night Weekend
Sensitivity
There are 5 levels of sensitivity for activity detection to ensure any scene
environment can be covered.
Note: When setting the sensitivity it is recommended that an Activity test is run
to ensure the correct sensitivity is selected.
Select the sensitivity level to suit the camera location:
• Cameras sited outdoors where there may be a lot of background
movement, such as trees or rain, should be set to Outdoor high, Outdoor
low or very low sensitivity.
• Cameras sited indoors where there is very little background movement
can be set to Indoor high or Indoor low sensitivity.
The sensitivity levels are:
• Indoor High (most sensitive setting).
• Indoor Low.
• Outdoor High.
• Outdoor Low.
• Very Low (lowest sensitivity level).
Activity Grid
A 16 x 16 grid can mask areas where activity detection is enabled. Select
'Setup' and follow the on-screen menus to configure the activity grid.
Note: An NTSC video source will display an activity grid of 16 x 14.
Use direction keys to navigate grid
Use camera 1 key to toggle cells on/off
Use camera 2 key to latch selection
Press MENU / MODE key to start setup
Press MENU / MODE key again to exit grid