Alarm Options - Dedicated Micros digital sprite 2 Setup Manual

Firewall Options
The Digital Sprite 2 supports enhanced network features, the firewall option
adds security to the system. It ensures only authorised users gain access to
the Digital Sprite 2 by utilising IP address and port filtering.
Note: It is recommended that the Firewall Options feature be configured via
the Web interface, refer to the Networking Guide for full configuration
information.

Alarm Options

The Alarm Options menu provides the ability to configure parameters that are
non specific to camera inputs.
Protect alarm images
Alarm Options
Main alarm display
Spot alarm display
Alarm buzzer
Camera fail buzzer
Relays
Alarm zone config
General contacts
Protect Alarm Period
It is possible to automatically protect alarm recordings to ensure these images
are not overwritten and remain in the hard drive of the unit. The images can be
protected for a set period of time (after which they will be automatically
overwritten) or indefinitely.
WARNING: Protecting images reduces the amount of space on the hard disk
and subsequently affects the storage capacity allocated to normal recordings.
Only keep protected images for as long as necessary.
Main and Spot Alarm Display
When an event occurs (Alarm, Activity or Both) on the Digital Sprite 2 it is
possible to determine how the alarm images can be viewed by the Operator.
The options available are;
Main alarm display (MON A)
• Last - If a number of alarms are triggered at the same time, the last alarm
image will be displayed on the monitor.
• Sequence - This will display all alarm images in a sequence.
• Multiscreen - If an alarm is triggered the unit will automatically switch to a
multiscreen display to allow all alarmed video inputs to be viewed.
Set period 000days
Set period, Indefinitely
Sequence Alarm
Last Both
No
No, Yes
No
No, Yes
Edit
Edit
Edit
27