Network Options - Dedicated Micros digital sprite 2 Setup Manual

Network Options

This option allows you to allocate properties to the Network connection of the
Digital Sprite 2.
Network Options
DHCP
TCP/IP address
Sub net mask
Default gateway
More Network Options
Remote Reporting
Email Settings
SMS Settings
Web Cam Settings
Firewall
DHCP
The Digital Sprite 2 needs a unique IP address and subnet mask to
communicate over a network.
The Digital Sprite 2 can be installed in a DHCP network environment where an
IP address, subnet mask and default gateway will be automatically allocated
from the network DHCP Server. This is enabled by default.
Disabling this option would require a static IP address and subnet mask to be
manually configured.
Important Note: A DHCP address is temporary and can change, therefore it is
recommended that the unit be allocated a fixed (permanent) IP address,
subnet mask and default gateway. Alternatively power up with DHCP enabled
and once an address has been assigned disable DHCP. The assigned IP
address will then be permanent.
24 24 24 24
Disabled, Enabled
Disabled
172.016.080.007
255.255.000.000
000.000.000.000
Edit
Enabled Edit Enabled, Disabled
Enabled Edit Enabled, Disabled
Enabled Edit Enabled, Disabled
Enabled Edit Enabled, Disabled
Edit
TCP/IP Address, Subnet mask, Default gateway
This allows a permanent IP address, subnet mask and default gateway to be
allocated to the Digital Sprite 2. On an existing network this information is often
obtained from the network Administrator. A Default gateway will be required if
the Digital Sprite 2 is to be accessed from a remote location, such as via a
WAN or dial-up using a router.
Note: DHCP must be disabled to configure a static IP address.
More Network Options
This submenu allows advanced network settings to be configured.
Bandwidth selection
More Network Options
PPP selection
Secondary web server port
Primary DNS
Secondary DNS
Bandwidth Selection
It is possible to set maximum limits for the bandwidth utilisation on the Network
port of the Digital Sprite 2.
Bandwidth Selection
Force 10 BaseT operation
Type
Max Trans Rate
Tx Image Buffers
Ethernet MTU
Ethernet re-tx t/o
Force 10 BaseT Operation
The Digital Sprite 2 supports a 10/100Mbps auto detecting connection,
however this option forces the network port on the Digital Sprite 2 to be a
10BaseT connection if the local hub/switch requires this.
Edit
Edit
0000
0000 - 9999
000.000.000.000
000.000.000.000
Disabled, Enabled
Disabled
CUSTOM, LAN, WAN, ISDN
LAN
000001 - 100000KBits/S
010000 KBits/Sec
1 - 3
3
576 - 1515
1500
0000 - 5000ms
0250 ms