Port Reset; Dhcp Relay; Dhcp Relay Agent Option 82; Dhcp Relay Setup - ZyXEL Communications NetAtlas IES-1000 User Manual

Select Yes and click Apply to reboot the system.
2.
The progress bar displays the status. Wait until the system reboot is complete.
3.
Click any button to close the screen.
4.
6.4.2

Port Reset

Follow the steps below to reset a port.
Click System, Reset and then Port Reset.
1.
Select a port number from the drop-down list box and click Apply.
2.
The progress bar displays the status. Wait until the reset process is complete.
3.
Click any button to close the screen.
4.

6.5 DHCP Relay

DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual clients to obtain
TCP/IP configuration at start-up from a server. You can configure the IES to relay client TCP/IP configuration
requests to a DHCP server and the server's responses back to the clients.
6.5.1

DHCP Relay Agent Option 82

The IES can add the originating slot and port numbers to client TCP/IP configuration requests that it relays to a
DHCP server. This helps provide authentication about the source of the requests. You can also specify additional
information for the IES to add to the client TCP/IP configuration requests that it relays to the DHCP server.
6.5.2

DHCP Relay Setup

To configure DHCP relay, click System and DHCP Setup to display the screen as shown.
The System Menus

Figure 6-7 System: Reset: Port Reset

NetAtlas IES-1000 (AAM1008) EMS User's Guide
6-5