Variable Loading Floor In The Luggage Compartment; Flexible Storage Compartment; Class N1 Vehicles - Skoda Fabia Owner's Manual

Flexible storage compartment


Read and observe and
The flexible storage compartment can be installed on either side of the boot
» Fig. 90.
Fitting
›
Place both ends of the storage compartment into the openings on the right
side panel of the boot.
›
Push the storage compartment down to lock it.
Removing
›
Grasp the storage compartment on the two upper corners.
›
Remove the storage compartment by pulling upwards and then towards you.
The storage compartment is designed for storing small objects with a maxi-
mum total weight of 8 kg.

Class N1 vehicles


Read and observe and
In class N1 vehicles that are not fitted with a protective grille, a lashing set that
complies with the EN 12195 standard (1-4) must be used for fastening the load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.
Fig. 90
Flexible storage compartment
on page 84 first.
on page 84 first.

Variable loading floor in the luggage compartment


Introduction
This chapter contains information on the following subjects:
Setting in the upper position
Setting in the lower position
Removing/inserting
Folding / Securing
The maximum permissible load of the variable loading floor is 75 kg. For the
transport of heavy loads, adjust the variable loading floor to the lower position
or remove it from the vehicle.
Setting in the upper position
Fig. 91 Set the variable loading floor to the upper position
The variable loading floor in the lower position can be set to the upper position
as follows.
›
Grasp the variable loading floor at handle » Fig. 91.
A
Transporting and practical equipment
89
90
90
91

89