Characters; Data Security Features - Worth Data TriCoder t53 User Manual

Characters

This setting allows the TriCoder to output chosen ASCII characters in place
of the actual characters entered. For example, if you scanned the number 1
(hex 31) and wanted the TriCoder to output hex 92 instead, you would enter
3192 for the Characters parameter. This would re-assign the output
characters, with the TriCoder outputting hex 92 every time it sees hex 31.
To re-assign characters:
• Scan Characters
• Scan up to seven 4-digit pairings where the first 2 digits represent the
hex number to replace and the second 2 digits represent the hex number
to insert. You can have up to seven character re-assignments.
• Scan SET
You can eliminate the output of a character by using FF as the hex number
to insert. For example, if you wanted to eliminate all $, following the above
instructions, enter 24FF.

Data Security Features

The TriCoder has two features that are there it ensure the integrity of your
data. The first feature is Data Security, which is found in the Protocol
setup parameter. Turning Data Security on prevents the operator from
editing data as well as not allowing them to exit Data Collection mode.
There is another security feature called Program Restriction that restricts
the user to one data collection program only. Program Restriction is set
only by keypad – at the
prompt, press the following keys on the TriCoder keypad:
F1
SHIFT D
SHIFT P
0,1,2, OR 3
F1
To reset the program restriction back to all programs, simply press the
ENTER key at the "ENTER PROGRAM # [0-3]" prompt.
NON PORTABLE MODE
KEY [YES/NO]?_
remember to press and release the key before pressing the next key
remember to press and release SHIFT before pressing D or P
you will see the prompt: ENTER PROGRAM # [0-3]_
press the number of the program you want to restrict the user to
6-25