Worth Data TriCoder t53 User Manual page 52

Starting the Receiving TriCoder
Make sure all cables are attached correctly and the 5-volt power adapter is
plugged in. To start the receiving TriCoder, answer NO to all prompts until
you see:
Press YES to get to the RECEIVE PROGRAM menu:
Press 0 to Clone the entire TriCoder. Cloning receives the programs, tables,
Setup, and voice messages (if using a voice cloning cable T15) from
another TriCoder.
Press 1, 2 or 3 to receive a program only. Pressing 1, 2 or 3 determines
which program number you are assigning - it does not have to correspond
to the program number being transmitted from the other TriCoder or host.
After making a selection, the TriCoder displays:
Once the transmission is complete, the receiving TriCoder displays:
Press any key to return to the Mode Menu.
If the TriCoder has a problem during the transmission, the transfer will end
and the TriCoder will display the following error message:
If you receive this message while receiving a program, the program transfer
is incomplete and the transmit/receive session will have to be restarted. To
avoid any problems, do not press any keys on the TriCoder once the
transmission has started.
PROGRAM RECEIVE?
KEY [YES/NO]?_
RECEIVE PROGRAM
------------------------------
Programs [1-3]?---------->1 - 3
Clone TriCoder?----------> 0
RECEIVING PROGRAM
PLEASE WAIT
END OF PGM. RECV
HIT ANY KEY_
DATA XMIT ERROR
CYCLE POWER
6-5
KEY
--------