Worth Data TriCoder t53 User Manual page 179

Special Laser and CCD Settings
There are several hidden settings on the TriCoder Setup Menu designed
specifically for laser and CCD performance:
Feature
Single Decode
Double Decode
CCD Trigger
Required
CCD Trigger Off
Quiet Zones
Short Decode
Long Decode
Difficult Code
Normal Code
For laser scanning through automobile windshields, use Difficult Code set
to C or D (go to D if C doesn't work) and turn OFF Double Decode.
Another laser feature which is only configurable by the keyboard is Aiming
Dot Duration. A DMA TriCoder with firmware version DMA2018 or
higher supports an aiming dot prelude with the internal lasers as well as
external LZ200-D scanners. The aiming dot duration is configurable to
th
1/10 of a second up to 9.9 seconds ( keying a value of 99). To enable the
aiming dot:
1. Go to Programming Mode,
2. Enter the Password (WDTRI)
3. Go to Change Setup (Press 5)
4. Go to Other
5. Press Enter until you get to Aiming Dot Duration.
6. Enter the number of seconds in 1/10
seconds)
An aiming dot can be useful for trying to read a bar code on a page of bar
codes, for reading in direct sunlight, and for distance reading.
Menu Setting
Code 39 -F
Code 39 -E
Computer Interface.-C
Computer Interface.-B
Computer Interface.-E
Computer Interface.-F
2 of 5 Code-E
2 of 5 Code-F
2of5 Code-C or D
2of5 Code-B
Description
Any decode is transmitted.
Takes 2 decodes for transmission.
triggered reading only
continuous reading – no trigger
required -- use with stand
Default is normal size
small quiet zones
2.5 Second laser beam
5 second laser beam
for difficult codes
normal code reading
th
you want,(i.e. 20 for 2
C-4