Default Voice Messages; Cloning Voice Messages From Tricoder To Tricoder - Worth Data TriCoder t53 User Manual

Default Voice Messages

The TriCoder comes from the factory with some voice prompts and error
messages pre-recorded. You can change any of these messages but keep in
mind that the error conditions that the voice error messages are linked to are
fixed. For example, the "Change Batteries" message is located at message
#31. Whenever the TriCoder detects very low batteries, it will play message
#31, regardless of what is recorded there. You could record "Happy
Birthday" and the TriCoder would broadcast it any time it detected the low
battery condition. To avoid confusion, try to keep the error messages
somewhat related to the error condition they represent.
Here are the default messages and the message numbers they are recorded
under:
Message Recorded
Prompts
ITEM
QUANTITY
Error messages
CHANGE BATTERIES
DATA FILE EXISTS
DATA TOO LONG
DATA TOO SHORT
DATA TYPE ERROR
DUPLICATE ACCESS
IDENTIFIER ERROR
ITEM NOT FOUND
OUT OF MEMORY
WRONG INPUT DEVICE
WARNING 2K LEFT
Cloning Voice Messages from TriCoder to
TriCoder
If you have several TriCoders, you can record all of your voice messages in
one TriCoder and simply "clone" them to your other TriCoders. Cloning
can also copy programs, tables, and the TriCoder setup. Cloning does have
certain conditions that need to be met before you start:
•
The TriCoders must be set to the same Computer Interface and
if set for Serial instead of Keyboard, all TriCoders must be set
to the same baud rate, parity, stop bits and data bits. TriCoders
with USB Computer Interface cannot clone from one TriCoder
to another, but you can change the Computer Interface on both
units to serial or keyboard wedge and then clone, (remember to
set it back to the appropriate USB Computer Interface).
Message #
#01
#02
#31
#32
#33
#34
#35
#36
#37
#38
#39
#40
#61
13-6