Uploading Firmware File Via Console Port (Only For Zyair B-2000); Example Xmodem Firmware Upload Using Hyperterminal; Figure 28-16 Menu 24.7.1 As Seen Using The Console Port; Figure 28-17 Example Xmodem Upload - ZyXEL Communications ZyAIR User Manual

ZyAIR Wireless Gateway Series User's Guide

28.4.8 Uploading Firmware File Via Console Port (only for ZyAIR B-2000)

Step 1.
Select 1 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu 24.7.1
– System Maintenance – Upload System Firmware, then follow the instructions as shown in
the following screen.

Figure 28-16 Menu 24.7.1 as seen using the Console Port

Step 2. After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your
computer. Follow the procedure as shown previously for the HyperTerminal program. The
procedure for other serial communications programs should be similar.

28.4.9 Example Xmodem Firmware Upload Using HyperTerminal

Click Transfer, then Send File to display the following screen.
After the firmware upload process has completed, the ZyAIR will automatically restart.
28-14
Menu 24.7.1 - System Maintenance - Upload System Firmware
To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning: Proceeding with the upload will erase the current system
firmware.
Do You Wish To Proceed:(Y/N)

Figure 28-17 Example Xmodem Upload

Type the firmware file's location, or
click Browse to look for it.
Choose the Xmodem protocol.
Then click Send.
Firmware and Configuration File Maintenance