Xerox Phaser 3200MFP Service Manual page 8

Introduction
Handling Precautions
The following instructions are for your own personal safety, to avoid injury and to prevent damage
to the machine
1. Ensure the machine is installed on a level surface, capable of supporting its weight. Failure to
do so could cause the machine to tip or fall.
2. The machine contains many rollers, gears and fans. Take great care to ensure you do not
catch your fingers, hair or clothing in any of these rotating devices.
3. Do not place any small metal objects, containers of water, chemicals or other liquids close to
the machine. If spilled, liquid could get into the machine and cause damage, electric shock or
a potential fire hazard.
4. Do not install the machine in areas with high dust or moisture levels, beside on open window
or close to a humidifier or heater. Damage could be caused to the machine in such areas.
5. Do not place candles, burning cigarettes, etc. on the machine. This could potentially cause a
fire.
Assembly / Disassembly Precautions
Replace parts carefully. Always use Xerox parts. Take care to note the exact location of parts and
also cable routing before dismantling any part of the machine. Ensure all parts and cables are re-
placed correctly.
Please carry out the following procedures before dismantling the machine or replacing any parts.
1. Check the contents of the machine memory and make note of any user settings. These will
be erased if the main board is replaced.
2. Ensure that power is disconnected before servicing or replacing any electrical parts.
3. Disconnect printer interface cables and power cables.
4. Only use approved spare parts. Ensure part numbers, product names, any voltage, current or
temperature ratings are correct.
5. Do not use excessive force when removing or re-fitting any parts, especially when fitting
screws into plastic.
6. Take care not to drop any small parts into the machine.
7. Handling of the OPC Drum
- The OPC Drum can be damaged if exposed to light.
Take care not to expose the OPC Drum either to direct sunlight, fluorescent or incandescent
room lighting. Exposure for as little as 5 minutes can damage the surface photoconductive
properties and will result in print quality degradation. Take extra care when servicing the
machine. Remove the OPC Drum and store it in a black bag or any other lightproof container.
Take care when working with the covers (especially the top cover) open as light will be admit-
ted into the OPC area and can damage the OPC Drum.
- Take care not to scratch the surface of OPC Drum.
If the green surface of the Drum Cartridge is scratched or touched, the print quality will be
compromised.
vi 04/07 Phaser 3200MFP / Workcentre PE220