Status Indicator RAPs
STATUS
Toner empty
Bypass jam
Group dial blocked
Retry redial?
No. not assigned
Load document
Memory full and cancel the
job
No job created
Low heat error
Open fuser error
Over heat error
No print cartridge
Memory dial full
--> Does the wall socket work?
--> Check the main PBA and cable harness.
3. Check the Paper Path
•
Is there a paper jam?
--> Remove any paper fragments caught in the paper path,
•
Paper jam occurs repeatedly at a specific point in the paper path.
--> Open the fuser cover and clear the jam,
--> Dismantle the machine and carefully inspect the region where the jam occurs.
Check if paper fragments are caught in the fuser, refer to
4. Print the System Data Page (Configuration).
•
If internal printing is good, print a test page from a computer.
--> If there is an error, check the cables and driver installation.
5. Check the Print Quality.
•
Is there a print quality problem?
--> Go to Section 3,
6. Check Consumables (toner etc.).
•
Print a test pattern,
--> Check the status of the consumables,
Enter Tech mode,
tridge,
PL 1.0
(Workcentre PE220) /
2-4
Table 1: LCD Status Error Messages
LCD Display
[Toner Empty]
[Bypass Jam]
Group Not Available
Retry Redial?
Number Not Assigned
Load Document
Cancel?
1:Yes 2:No
Operation Not
Assigned
[Low Heat Error]
Open Fuser Error
[Over Heat]
[Jam 1]
[No Cartridge]
Memory Dial Full
Image Quality.
GP
4.
GP
4. Check the CRU print count. If necessary, install a new toner car-
PL1.1
Toner empty.
Bypass paper feed failure.
Only single number location may be used.
Fax redial delay interval allows job cancel.
Fax speed dial location has no number assigned.
Place original document in the ADF or on the platen
glass.
Press 1 to transmit scanned pages in memory.
Add/cancel job number not found.
Fuser has not warmed up within the time limit.
Fuser thermistor is open or disconnected.
Fuser temperature went over limit.
Print cartridge is not installed.
Auto dial transmission limit is 15 jobs.
GP
GP
7.
REP
GP
1.
(Phaser 3200).
04/07
Descriptions
7.
16.
Phaser 3200MFP / Workcentre PE220