Dell Z9500 Reference Manual page 1566

Defaults Use the enable password.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.0
Usage
By default, the Enable password is used. If you configure aaa authentication
Information
enable default, the system uses the methods defined for Enable access
instead.
Methods configured with the aaa authentication enable command are
evaluated in the order they are configured. If authentication fails using the primary
method, the system employs the second method (or third method, if necessary)
automatically. For example, if the TACACS+ server is reachable, but the server key
is invalid, the system proceeds to the next authentication method. The TACACS+ is
incorrect, but the user is still authenticated by the secondary method.
Related
enable password
Commands
login authentication
password
radius-server host
tacacs-server host
1566
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— changes the password for the enable command.
— enables AAA login authentication on the terminal lines.
— creates a password.
— specifies a RADIUS server host.
— specifies a TACACS+ server host.
Security