Radius-Server Retransmit - Dell Z9500 Reference Manual

Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.5.1.0
6.2.1.0
Usage
The key configured on the switch must match the key configured on the RADIUS
Information
server daemon.
If you configure the key parameter in the radius-server host command, the
key configured with the radius-server key command is the default key for all
RADIUS communications.
Related radius-server host
Commands

radius-server retransmit

Configure the number of times the switch attempts to connect with the configured RADIUS host server
before declaring the RADIUS host server unreachable.
Z9500
Syntax
radius-server retransmit retries
To configure zero retransmit attempts, use the no radius-server retransmit
command.
To return to the default setting, use the radius-server retransmit 3
command.
Parameters
retries
Defaults 3 retries
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
1588
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Authentication key length increased to 42 characters.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures a RADIUS host.
Enter a number of attempts that the system tries to locate a
RADIUS server. The range is from zero (0) to 100. The default
is 3 retries.
Security