Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
b. CYCLE SELECTOR OR WASH
TEMPERATURE SWITCH:
1. Remove two control panel attaching screws
and lay assembly forward on protective pad
on cabinet top.
2. Loosen setscrew holding switch knob to
switch shaft, Figure 7.
3. Remove knurled nut holding switch to
control panel, Figure 7.
NOTE: Lockwasher must be between switch and
control panel when installing switch, Figure 7.
4. Disconnect wires from switch.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
c. INDICATOR LIGHTS — (Unbalanced Load
In Use, Rinse or Spin, Figure 6 ):
1. Remove two control panel attaching screws
and lay assembly forward on protective pad
on cabinet top.
2. Disconnect wires from light.
NOTE: Refer to wiring diagram when rewiring
light.
3. Squeeze locking tabs together and pull light
out rear of control panel.
d. PRESSURE SWITCH (Figure 6)
1. Remove two control panel attaching screws
and lay assembly forward on protective pad
on cabinet top.
2. Remove two screws holding switch to
cabinet top .
3. Pull switch out of control hood far enough
to disconnect pressure hose and wires
from switch.
NOTE: Refer to appropriate wiring diagram when
rewiring pressure switch.
IMPORTANT: When installing pressure switch,
blow air into hose before connecting hose to
switch to remove any moisture that may have
accumulated in hose.
WASH
TEMPERATURE
SWITCH
CYCLE
SELECTOR
SWITCH
SETSCREW
8
LOCKWASHER
PANEL SCREW
KNOB
KNURLED
NUT
W235SE1A
Figure 7
W003
37989
Advertisement
Table of Contents
