Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
21. OUTER TUB COVER AND CLOTHES GUARD
a. Remove agitator, paragraph 15.
b. Raise cabinet top, paragraph 16.
c. Loosen hose clamp and remove filler hose
from outer tub cover, Figure 34.
NOTE: When installing filler hose, white line on
hose must be aligned with line located on top side
of outer tub cover, Figure 34.
37989
OUTER
TUB COVER
HOSE
FILLER
CLAMP
HOSE
HOLD-DOWN
TABS
Figure 34
d. There are eight tub cover hold-down tabs
which snap over the outer tub flange. Using
special tub cover tool, Part No. 273P4,
insert two prongs of tool underneath each side
of tandem tabs, Figure 34. Tilt tool toward
center of tub cover and at the same time lift
upward on cover to unsnap hold-down tabs
from outer tub flange. One by one, disengage
each of the eight hold-down tabs from outer
tub flange and remove cover.
29
LINE ON
COVER
273P4
TUB COVER
TOOL
W343SE3A
(continued)
W003
Advertisement
Table of Contents
