Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
TURN ADJUSTABLE WRENCH
COUNTERCLOCKWISE
TO REMOVE DRIVE BELL
Figure 26
h. After drive bell has been pulled, remove tool
and drive bell by turning quarter inch bolt out
of transmission output shaft.
i. Loosen wing nuts and remove drive bell from
tool.
j. Remove old seal from hub assembly by:
1. Placing a flat bladed screwdriver
between bottom edge of seal and hub.
2. Using washtub bolts as a pry area, pop off
lower seal bead.
3. Grasping bottom of seal, pull straight up
freeing upper seal bead.
HEX
NUT
HUB
ASSEMBLY
HUB SHOULDER
Figure 27
37989
IMPORTANT: DO NOT allow any lubricants to
come in contact with outside surface of seal.
W293SE1A
TRANSMISSION
OUTPUT SHAFT
WASHER
BRONZE
BEARING
W294SE1A
25
k. Thoroughly clean all foreign material from seal
mounting area of hub assembly, bronze
bearing and washer, Figure 27.
l. Lubricate new seal with liquid soap or soapy
water to aid in assembly of seal onto hub,
Figure 28.
m.Apply a small amount of supplied grease,
No. 36765P, to inside sealing lips of seal,
Figure 28.
n. Apply remainder of supplied grease, Part No.
36765P, to exposed surface of washer
between transmission output shaft and seal.
APPLY GREASE TO
INSIDE SEALING LIPS
HUB
ASSEMBLY
Figure 28
W003
TRANSMISSION
OUTPUT SHAFT
SEAL
W295SE1B
(continued)
Advertisement
Table of Contents
