Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
28. BALANCE RING
a. Remove transmission assembly,
paragraph 27.
b. Lift balance ring off outer tub.
IMPORTANT: When reinstalling balance ring, note,
if there is a mark located on outer edge of balance
ring, this mark (if present) indicates light side of
ring. This light side must be installed at a 9
o'clock position with center of rack at 12 o'clock
when viewed from top of transmission, Figure 44.
NOTE: If there is no mark on balance ring before
disassembly, mark it and also note the position of
rack on transmission assembly, Figure 44.
BALL BEARING
UPPER
BEARING
HOUSING
37989
OUTER
FLINGER
(If Present)
29. UPPER BEARING ASSEMBLY
a. Remove transmission assembly,
paragraph 27.
b. Remove screws holding each support leg to
outer tub, Figure 41.
c. Lift complete pivot dome (with drive pulley,
brake assembly, lower bearing housing,
transmission assembly, and balance ring
attached) off outer tub.
IMPORTANT: To prevent porcelain damage, leg
plates must be installed on outer tub flange when
reinstalling support legs. (Plate must be installed
on the outside of tub flange). Do not overtighten
screws as this could cause stripping or porcelain
damage.
c. Remove three screws holding upper bearing
and housing to bottom of outer tub, Figure 46.
NOTE: Replace bearing and housing as an
assembly, and make sure flinger (if present) is
properly positioned between outer tub and
bearing assembly, Figure 46.
NOTE: When reinstalling upper bearing assembly,
applying a retaining compound to threads of cap
screws.
TUB
UPPER
BEARING
HOUSING
Figure 46
45
CAP SCREW
FLINGER
(If Present)
W003
W196SE3A
Advertisement
Table of Contents
