Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
e. Reach in and around right side of motor and
run belt off right side of large drive pulley,
Figure 17 .
f. Disconnect wire harness from motor switch
by pressing down on locking tab on top of
connection block and at the same time pull
connection block away from motor switch,
Figure 18 .
g. Remove four screws holding motor and
mounting bracket to washer base, Figure 18 ,
then lift complete assembly out of washer.
IMPORTANT: Carefully lay motor on its side.
Observe belt configuration around rear pump leg.
Belt MUST encircle rear pump leg when
reassembling, Figure 19 .
PUMP AND BELT REMOVAL
a. Remove three screws holding pump
assembly to motor, Figure 19 .
REASSEMBLY OF PUMP AND BELT
IMPORTANT: Install pump and belt together.
Drive belt MUST be replaced with belt No. 35517
(50 Hertz) (special clutch-type belt) for proper
washer operation.
a. Clean any corrosion or foreign material from
motor shaft that will be contacting the double
"D" slot in pump impeller.
b. Apply a thin film of No. 03637P Lubricant to
end and sides of motor shaft. This lubricant
helps keep moisture out of the hub area and
retards corrosion.
c. Align pump impeller hub with motor shaft.
Make sure belt encircles rear pump leg,
carefully push pump onto motor shaft so three
pump legs bottom out in the embosses on
motor housing before screws are tightened,
Figure 19 .
d. Tighten three screws to 35 inch-pounds
(4.0N-m) (maximum). DO NOT overtighten
screws!
e. Reinstall motor and pump assembly into
washer.
IMPORTANT: After installing motor and pump
assembly in washer and all hoses have been
reconnected, add at least a quart of water to
washtub to lubricate pump seals. Running a pump
without water will ruin its seals.
MOTOR REMOVAL
Remove nuts, steel washers, spacers and rubber
mounts holding motor to mounting bracket,
Figure 20. Lift motor off mounting bracket and
remove balance of rubber mounts and steel
washers from motor mounting studs.
IMPORTANT: When installing motor on mounting
bracket, position motor with switch facing toward
left side of mounting bracket.
NOTE: Refer to Figure 20 for motor and mounting
bracket assembly sequence.
WIRE
HARNESS
IDLER
SPRING
16
MOTOR
SWITCH
DRIVE
HOSE
CLAMPS
W363SE1A
Figure 17
W003
BELT
37989
Advertisement
Table of Contents
