Table of Contents
Advertisement
g WARNING
32. PRESSURE SWITCH (Refer to Figure 50 )
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
NOTE: DO NOT ADJUST PRESSURE SWITCH IF
• Never start the washer with any guards/panels removed.
WASHER IS WITHIN WARRANTY PERIOD.
• Whenever ground wires are removed during servicing, these ground wires must be
Pressure switch is set at the factory for proper
reconnected to ensure that the washer is properly grounded.
water fill levels. However, if there is a problem of
overfilling or underfilling, pressure switch can be
adjusted.
Maximum water fill level can be increased by
turning adjusting screw CLOCKWISE, and
decreased by turning screw
COUNTERCLOCKWISE.
One quarter turn of adjusting screw represents
approximately one inch (25.4 mm) increase or
decrease of water level in washtub.
IMPORTANT: DO NOT turn adjusting screw more
than 3/4 of a turn in either direction as switch may
be damaged and flooding could result.
ADJUSTING
SCREW
Figure 50
33. OUT-OF-BALANCE SWITCH
a. Raise cabinet top assembly, paragraph 16.
b. Check for bent actuator arm or lever,
Figure 51.
IMPORTANT: If switch lever repeatedly trips the
out-of-balance switch, check centering of agitator
within loading door opening. If tub module is not
centered within opening, centering spring(s) may
have been overstretched. Replace necessary
spring(s) and recheck centering, Figure 52.
IMPORTANT: DO NOT APPLY ANY
LUBRICANT to surface of snubber pad and
isolator assembly or pivot dome. Any lubricant on
pivot dome or isolator will cause premature
tripping of out-of-balance switch.
34. BELT (Agitate and Spin)
No belt adjustment is required.
W261SE1A
50
ACTUATOR
OUT-OF-BALANCE
SWITCH ASSEMBLY
Figure 51
HOLES
CENTERING
SPRING
Figure 52
ARM
W003
LEVER
W277SE1A
W365SE1B
37989
Advertisement
Table of Contents
