Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
39. TIMER DOES NOT ADVANCE (Mechanical Timer Models only)
POSSIBLE CAUSE
Timer is designed to pause during fill periods.
Inoperative timer.
Loading door is open.
Washer will not fill.
Timer motor lead wire off timer terminal.
Broken, loose or incorrect wiring.
Timer is designed to pause when going from agitate
to spin.
Timer is designed to stop if an out-of-balance load
has been encountered while washing clothes load.
Timer is designed to stop if washer drive motor has
been over loaded and motor thermal overload has
tripped.
Is circuit breaker to washer tripped, disconnecting
power to washer.
Washer will not fill.
37989
TO CORRECT
Allow completion of fill period.
Test timer, and replace if inoperative.
Close loading door. Loading door MUST be
closed any time washer is set to fill, agitate or spin.
Timer pauses until pressure switch is satisfied.
Refer to appropriate wiring diagram and reattach
wire.
Refer to appropriate wiring diagram.
Allow time for timer to go through that step. See
diagram for information on time required.
Open lid and automatically reset out-of-balance
switch when lid is closed.
Motor thermal protector reset time may vary
depending upon the reason for the washer overload,
however, it should reset within 15 minutes. Check
to ensure that washer was not overloaded with
clothes.
Reset circuit breaker.
Timer is designed to pause when going from spin into
rinse to allow the washtub to stop spinning before
filling, make sure that timer has advanced into fill
portion of rinse cycle.
53
W003
Advertisement
Table of Contents
