Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
IMPORTANT: When reference is made to
directions (right or left) in this manual, it is from
the operator's position facing the front of the
washer.
5. CONTROL PANEL ASSEMBLY
a. CONTROL PANEL:
1. Remove two control panel attaching screws
and lay assembly forward on a protective
pad on cabinet top, Figure 5.
2. Unplug wire harness quick disconnect
blocks, two earth (ground) wires and leads
from pressure switch and loading door
switch, Figure 6.
NOTE: Refer to appropriate wiring diagram when
reconnecting wire harnesses, earth (ground) and
switch leads.
DISCONNECT
BLOCKS
37989
SECTION II
Service Procedures
PRESSURE
SWITCH
INDICATOR
LIGHT
PANEL
ATTACHING
SCREWS
DISCONNECT
BLOCKS
EARTH
(Ground)
WIRES
Figure 6
7
W284SE1A
Figure 5
EARTH
(Ground)
WIRES
W362SE3A
(continued)
W003
W003
Advertisement
Table of Contents
