Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
19. OUT-OF-BALANCE SWITCH ASSEMBLY
a. Open control panel assembly, paragraph 5.
b. Move switch lever off switch plunger,
Figure 32, by moving lever back under cabinet
top.
c. Place a thin piece of metal or paper in front of
switch to keep screws from falling through
holes in switch holder.
d. Use an open-end wrench, remove screws
holding switch to switch holder, Figure 31.
e. Remove switch and screws from switch
holder.
f. Insert screws into holes in new switch.
g. Place a thin piece of metal or paper in front of
switch to keep screws from falling through
holes in switch holder.
h. Place switch assembly into switch holder,
Figure 31.
i. Tighten screws using an open-end wrench
and torque to 10 inch-pounds (1.14 N-m).
CABINET
SCREWS
Figure 31
37989
TOP
W273SE1B
NOTE: Make sure switch is secure within holder
by wigging it back and forth.
j. Reset switch lever by raising and lowering
loading door.
NOTE: Make sure switch lever tab locates itself on
top of switch plunger.
k. Reconnect wires to switch terminals.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
l. Reinstall control panel assembly on control
hood.
CABINET
TOP
27
PUSH
HERE
SWITCH
LEVER
W171SE1A
Figure 32
W003
Advertisement
Table of Contents
