Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
k. Remove four screws and washers holding
washtub to hub, Figure 37.
l. Lift washtub and clothes guard out of outer
tub.
IMPORTANT: When removing washtub and clothes
guard, DO NOT lift up on the clothes guard as you
could damage it. Grasp top flange of washtub and
remove from outer tub.
NOTE: When installing washtub, make sure all
traces of old gasket are removed from bottom of
washtub. When installing washtub, always use a
new gasket between washtub and hub.
WASHTUB
SCREWS
WASHTUB
SCREWS
m.CLOTHES GUARD REMOVAL:
1. Place blade of a small screwdriver into
slots between clothes guard and washtub,
Figure 37.
2. Carefully pry pins of clothes guard out of
holes in washtub, Figure 37.
NOTE: As you are prying out pins, lift up on
clothes guard.
3. Pry pins out of washtub holes
approximatelyhalf way around tub before
clothes guard can be removed.
n. CLOTHES GUARD INSTALLATION:
Place clothes guard on top of washtub,
making sure clothes guard pins line up with
holes in washtub. Then carefully push clothes
guard down into washtub until all pins snap
into their respective holes.
CLOTHES
GUARD
Figure 37
32
SLOTS
PINS
W209SE3A
W003
37989
Advertisement
Table of Contents
