Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
10. FRONT PANEL ( Figure 16 )
a. Remove two screws from bottom edge of
front panel.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
Hold-Down Clips
Compress hold-down clips enough to remove
them from slots in top flange of panel.
Guide Lugs
Remove screws holding guide lugs to side
flanges of front panel.
Brace
Remove screws holding brace to side flanges
of front panel. Remove brace from front panel
by swinging one end toward bottom of front
panel and remove brace.
37989
11. MOTOR AND MOUNTING BRACKET
a. Remove two screws from bottom edge of
front panel, Figure 16.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
IMPORTANT: There will always be some water that
will remain in outer tub, therefore, before
removing hoses from pump, hoses must be
pinched off or drained to prevent water spillage.
c. Loosen hose clamps and remove hoses from
pump assembly, Figure 17 .
d. Unhook idler spring from clip on front of motor
mounting bracket, Figure 17.
IMPORTANT: Use care when releasing idler lever
tension. If idler spring is overstretched, washer
operation will be affected.
CABINET TOP
HOLD DOWN
SCREWS
FRONT
PANEL
SCREWS
Figure 16
15
W003
HOLD-DOWN
CLIP
W292SE3A
Advertisement
Table of Contents
