g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the washer before servicing.
Never start the washer with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
44. SLOW SPIN OR NO SPIN
POSSIBLE CAUSE
Inoperative timer.
Loading door is open or door safety switch is
inoperative.
Bind in water pump.
Broken drive belt.
Washer has gone OUT-OF-BALANCE.
Motor will not run.
Sheared motor pulley roll pin.
Motor overload protector has cycled.
No clearance or stuck brake pads.
Broken, loose, or incorrect wiring.
Inoperative transmission assembly.
45. CONSTANT SPIN
POSSIBLE CAUSE
Inoperative timer.
Washtub does not stop spinning within seven
seconds after loading door is opened.
Excessive wear on brake pads, or missing
brake pads.
Shorted or incorrect wiring.
TO CORRECT
Test timer and replace if inoperative.
Close loading door, or test switch and replace if
inoperative.
Replace pump.
Replace belt.
Open loading door to reset OUT-OF-BALANCE
switch. Rearrange load in washtub.
Check motor and replace if inoperative.
Remove drive motor and replace roll pin and
any other damaged parts.
Wait two or three minutes for overload protector
to reset. If protector cycles repeatedly, refer to
paragraph 43.
Free sticky brake pads or replace pads.
Refer to appropriate wiring diagram.
Repair or replace transmission assembly.
TO CORRECT
Test timer and replace if inoperative.
Replace brake pads.
Replace brake pads.
Refer to appropriate wiring diagram.
56
W003
37989