Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
13. MOTOR DRIVE PULLEY
a. Remove two screws from bottom edge of
front panel, Figure 16.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
IMPORTANT: There will always be some water that
will remain in outer tub, therefore, before
removing hoses from pump, hoses must be
pinched off or drained to prevent water spillage.
c. Loosen hose clamps and remove hoses from
pump assembly, Figure 18.
d. Unhook idler spring from idler lever, Figure 20.
IMPORTANT: Use care when removing idler
spring. If idler spring is overstretched, washer
operation will be affected.
e. Reach in and around right side of motor and
run belt off right side of large drive pulley,
Figure 17.
f. Disconnect wire harness from motor switch
by pressing down on locking tab on top of
connection block and at the same time pull
connection block away from motor switch,
Figure 18.
g. Remove four screws holding motor assembly
to washer base, Figure 18 , then lift complete
assembly out of washer.
h. Lay motor assembly on its side.
NOTE: To remove pulley, support motor shaft (to
prevent bending shaft) and drive out pulley roll
pin, Figure 20 .
18
W003
37989
Advertisement
Table of Contents
