Raytheon ec2011wa3059 Service Manual page 35

Table of Contents

Advertisement

g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
i. While holding down hub assembly, place new
spline insert (with fingers pointing upward)
over transmission tube until it bottoms out on
hub assembly.
IMPORTANT: Use spline insert (supplied in kit)
when reinstalling large hex nut. DO NOT reuse
any old spline insert because the large hex nut
may loosen during washer operation.
j. Place large hex nut over transmission tube
(with larger inside bevel toward spline insert)
then finger tighten large hex nut.
k. Torque large hex nut between 40 to 70 foot-
pounds (5.56 to 9.73 Kgm).
NOTE: If torque wrench is not available, place
No. 237P4 Hex Wrench over large hex nut then tap
hex wrench with a hammer until hub assembly
turns or until large hex nut will no longer tighten.
WATER
PRESS HERE
TO ASSEMBLE
GARTER
SPRING
APPLY BEAD OF
NO. 27615P
SEALANT (3M800) HERE
(Step "f")
STAINLESS STEEL
SEAL
LUBRICATE
(Step "c")
INSERT STAINLESS STEEL
SLEEVE FROM BOTTOM SIDE OF SEAL
l. To install No. 27125 washtub gasket, follow
these steps:
1. Thoroughly clean all foreign material from
seal surface area of hub and bronze
bearing.
2. Apply a small amount of nonstaining
petroleum jelly (such as Vaseline
surfaces where gasket will contact hub
assembly and bottom of washtub.
3. Carefully place No. 27125 washtub gasket
(supplied in kit) on hub assembly.
NOTE: Ensure holes in gasket are aligned with
holes in hub assembly and all traces of original
washtub gasket are removed from bottom of
washtub.
m.Grasp top flange of washtub and carefully
lower washtub down onto gasket and hub
assembly.
BRONZE PORTION
SLEEVE
LUBRICATE
(Step "c")
Figure 39
34
OF SEAL
APPLY BEAD OF
NO. 27615P
SEALANT (3M800) HERE
(Step "f")
W003
®
) to both
FLUSH
GARTER
SPRING
W180SE3B
37989

Advertisement

Table of Contents
loading

Table of Contents