Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
g WARNING
reconnected to ensure that the washer is properly grounded.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
IMPORTANT: Refer to appropriate Wiring Diagram for aid in testing washer components.
35. NO HOT WATER
POSSIBLE CAUSE
Hot water supply faucet is closed.
Water supply is cold.
Kinked hot water inlet hose.
Clogged mixing valve screen, or screen in outer
end of inlet hose nearest water supply faucet.
Inoperative hot water mixing valve solenoid.
Inoperative timer.
Inoperative temperature switch.
Inoperative pressure switch.
Clogged pressure hose.
Broken, loose, or incorrect wiring.
36. NO COLD WATER
POSSIBLE CAUSE
Cold water supply faucet is closed.
Kinked cold water inlet hose.
Clogged mixing valve screen, or screen in outer
end of inlet hose nearest water supply faucet.
Inoperative cold water mixing valve solenoid.
Inoperative timer.
Inoperative temperature switch.
Inoperative pressure switch.
Clogged pressure hose.
Broken, loose, or incorrect wiring.
37989
SECTION IV
Service Helps
TO CORRECT
Open faucet.
Check water heater.
Straighten or replace hose.
Disconnect hot water inlet hose, and clean or
replace screen.
Test solenoid and replace if inoperative.
Test timer and replace if inoperative.
Test switch and replace if inoperative.
Test switch and replace if inoperative.
Remove and clean or replace hose.
Refer to appropriate wiring diagram.
TO CORRECT
Open faucet.
Straighten or replace hose.
Disconnect cold water inlet hose, and clean or
replace screen.
Test solenoid and replace if inoperative.
Test timer and replace if inoperative.
Test switch and replace if inoperative.
Test switch and replace if inoperative.
Remove and clean or replace hose.
Refer to appropriate wiring diagram.
51
W003
W003
Advertisement
Table of Contents
