Table of Contents
Advertisement
g WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
8. DRAIN HOSE ELBOW
a. Loosen hose clamp and remove drain hose
from elbow, Figure 13.
b. Remove screws holding elbow to rear of
washer cabinet, Figure 13 .
c. Pull elbow out through opening in cabinet far
enough to loosen inner clamp, then remove
elbow from inner hose.
NOTE: When installing elbow on inner hose, DO
NOT allow hose inside of washer to twist! Direct
elbow toward drain receptacle and secure elbow
to washer cabinet.
ELBOW
ATTACHING
SCREWS
DRAIN
HOSE
Figure 13
37989
HOSE
CLAMP
W242SE1A
9. LOADING DOOR
a. Open loading door, Figure 14.
b. Remove two screws holding left hinge to door
and remove gasket (if present) and hinge,
Figure 14.
c. With loading door raised to vertical position,
swing left side of door toward front of washer,
Figure 15 , procedure one.
d. Rotate loading door so door is upside down,
Figure 15, procedure two.
e. Remove loading door, right door hinge and
bushing from cabinet top, Figure 15,
procedure three.
NOTE: Reverse procedures when installing
loading door.
HINGE
ATTACHING
SCREWS
LEFT
HINGE
13
LOADING
DOOR
RIGHT
HINGE
W287SE1A
Figure 14
W003
Advertisement
Table of Contents
