Oil Pump Installation - KYMCO People Service Manual

4. LUBRICATION SYSTEM
Install the pump cover by aligning the hole in
the cover with the dowel pin.
Tighten the screw to secure the pump cover.
Make sure that the pump shaft rotates freely
without binding.

OIL PUMP INSTALLATION

Install the oil pump and oil separator and
tighten the two bolts.
Make sure that the pump shaft rotates freely.
The arrow of oil pump is upside.
Install the pump drive chain and driven gear,
then set the circlip securely on the pump
shaft.
Install the oil separator cover properly.
Fit the tab of the separator cover into the
slit in the separator.
Install the A.C. generator starter driven gear.
( Ö 10-8)
PEOPLE/PEOPLE S 250
Hole
Pump Cover
Dowel Pin
Arrow Mark
Bolts
Oil Pump Driven Gear
Oil Pump Drive chain
Bolts
Oil Separator Cover
Screw
Pump Shaft
Oil Pump
Circlip
4-6