Firmware And/Or System Electronics (900-999) - Lexmark C792e 5062-210 Service Manual

5062
Firmware and/or system electronics (900–999)
Error code
900.00–900.99
(except 900.05)
Software Error
910.xx–915.xx
Engine Software Error
938.01
Electronics Hardware
Error
938.02
Electronics Hardware
Error
938.03–938.04
Electronics Hardware
Error
938.05–938.08
Electronics Hardware
Error
938.09
Electronics Hardware
Error
938.10
Electronics Hardware
Error
938.11–938.14
Electronics Hardware
Error
938.15
Electronics Hardware
Error
938.16
Electronics Hardware
Error
938.18
Electronics Hardware
Error
938.19
Electronics Hardware
Error
938.20
Electronics Hardware
Error
2-52
Service Manual
Description
An unrecoverable RIP software error
occurred while an unknown process
was running.
An engine software error has
occurred.
The system board is not the correct
level.
A system board timeout error has
occurred.
A communication error has occurred.
Under-voltage was detected.
The printhead PLL failed to achieve
lock.
The humidity sensor failed.
A cartridge sensor failed.
An output bin sensor not connected
error occurred.
An MPF paper out sensor not
connected error occurred.
A waste toner sensor not connected
error occurred.
A waste toner full sensor not
connected error occurred.
A duplex motor failure occurred.
Action
• POR the printer.
• If the error message persists, go to
Software error service check" on page
• POR the printer.
• If the error persists, replace the system board.
See "System board removal" on page
• POR the printer.
• If the error persists, replace the system board.
See "System board removal" on page
• POR the printer.
• If the error persists, replace the system board.
See "System board removal" on page
• POR the printer.
• If the error persists, replace the system board.
See "System board removal" on page
• POR the printer.
• If the error message persists, replace the LVPS.
See "Low-voltage power supply (LVPS)
removal" on page 4-82.
• POR the printer.
• If the error message persists, go to
Printhead error service check" on page
• POR the printer.
• If the error message persists, go to
board removal" on page
• POR the printer.
• If the error message persists, go to
Cartridge sensor error service check" on
page 2-64.
• POR the printer.
• If the error message persists, go to
sensor service check" on page
• POR the printer.
• If the error message persists, go to
MPF paper out sensor error service check"
on page 2-103.
• POR the printer.
• If the error message persists, go to
Waste toner sensor error service check" on
page 2-104.
• POR the printer.
• If the error message persists, go to
Waste toner full sensor error service check"
on page 2-105.
• POR the printer.
• If the error message persists, go to
Duplex motor error service check" on
page 2-74.
"900.xx—
2-102.
4-142.
4-142.
4-142.
4-142.
"110.xx—
2-57.
"System
4-142.
"133.xx—
"Bin-full
2-131.
"938.16—
"938.18—
"938.19—
"150.xx—