5-Bin Mailbox Output Bin Sensors Removal; 5-Bin Mailbox Rear Cover Removal - Lexmark C792e 5062-210 Service Manual

5062
Lower four bails:
1.
Squeeze both sides of the bail to release the arms from the slots.
2.
Remove the bail.

5-bin mailbox output bin sensors removal

1.
Remove the mailbox from the printer.
2.
Remove the rear cover. See
3.
Press in the tabs to pop out the sensor you need to replace.
4.
Disconnect the cable to remove the sensor.
Installation note: When you put the sensor in place, be sure the side with the cable connector faces the printer
circuit board.
4-238
Service Manual
"5-bin mailbox rear cover removal" on page 4-239.