Lexmark C792e 5062-210 Service Manual page 82

5062
Error code
37 Insufficient memory,
Some Held Jobs Were
Not Restored
37 Insufficient memory,
Some Held Jobs Will
Not Be Restored
37 Insufficient Defrag
Memory
38 Memory Full
39 Complex Page
50 PPDS Font Error
51 Defective Flash
52 Flash Full
53 Unformatted Flash
2-44
Service Manual
Action
• The printer deleted some held jobs in order to process current jobs.
• Select Continue to clear the message.
• If this does not fix the problem, replace the system board. See
on page 4-142.
• The printer was unable to restore some or all of the confidential or held jobs on the hard
disk.
• Select Continue to clear the message.
• If this message occurs again, replace the hard drive.
• If this does not fix the problem, replace the system board. See
on page 4-142.
There is insufficient memory to perform the Flash Memory Defragment operation. The user
can:
• Delete font, macros, and other data in memory.
• Install additional printer memory.
The following options are available:
• Select Continue to clear the message and continue printing. The job may not print
correctly.
• Cancel the current job.
• Install additional printer memory.
• If this does not fix the problem, replace the system board. See
on page 4-142.
The page is too complex to print. Options are:
• Select Continue to continue. The job may not print correctly.
• Cancel the job.
• Select Continue to clear the message and continue printing. The job may not print
correctly.
• Cancel the current job.
• If this does not fix the problem, replace the system board. See
on page 4-142.
• Select Continue to clear the message and continue printing.
• Install different flash memory before downloading any resources to flash.
• If this does not fix the problem, replace the system board. See
on page 4-142.
• Select Continue to clear the message and continue printing.
Note: Downloaded fonts and macros not previously stored in flash memory are deleted.
• Delete fonts, macros, and other data stored in flash memory.
• Install a larger capacity flash memory card.
• If this does not fix the problem, replace the system board. See
on page 4-142.
• Select Continue to clear the message and continue printing.
• Format the flash memory before storing any resources on it. If the error message
remains, replace the flash memory.
• If this does not fix the problem, replace the system board. See
on page 4-142.
"System board removal"
"System board removal"
"System board removal"
"System board removal"
"System board removal"
"System board removal"
"System board removal"