Exiting The Diagnostics Mode; Dual Diode Adjust; Registration - Lexmark C792e 5062-210 Service Manual

Par 1 Strobe Adj (if installed)
EP SETUP
EP Defaults
Fuser Temp
DC Charge Adjust
Dev Bias Adj
Transfer Adjust
Op Point Boost
REPORTS
Menu Settings Page
EVENT LOG
Display Log
Print Log
Clear Log
Exit Diags

Exiting the Diagnostics mode

Select Exit Diags to exit the Diagnostics mode and return to the printer home screen.

DUAL DIODE ADJUST

Adjust the dual diode alignment before adjusting the Registration or Alignment settings.
1.
From the Diagnostics menu, navigate to:
DUAL DIODE ADJUST > Diode Alignment Page
An alignment page prints.
2.
Follow the instructions on the alignment page and use the touch screen to adjust the dual diode alignment
for Black, Cyan, Magenta, and Yellow.
3.
Reprint the alignment page and adjust the settings as needed.

REGISTRATION

Note: Before adjusting the Registration or Alignment settings, you must adjust the dual diode alignment. See
"DUAL DIODE ADJUST" on page
Use REGISTRATION to align the black image on the page. Use Alignment to align the individual colors. The
black image should be aligned before the individual colors are aligned.
To set Registration:
1. Print the Quick Test page:
a.
From the Diagnostics menu, navigate to:
REGISTRATION > Quick Test
See "Par 1 Strobe Adj" on page
See "EP Defaults" on page
See "Fuser Temp" on page
See "DC Charge Adjustment" on page
See "Dev Bias Adj" on page
See "Transfer Adjust" on page
See "Op Point Boost" on page
See "Display Log" on page
See "Print Log" on page
See "Clear Log" on page
3-9.
3-23.
3-23.
3-23.
3-23.
3-23.
3-23.
3-23.
3-24.
3-24.
3-24.
Diagnostic aids
5062
3-9