950.00-950.29-Eprom Mismatch Failure - Lexmark C792e 5062-210 Service Manual

5062
950.00–950.29—EPROM mismatch failure
Warning: When replacing any of the following components, replace only one component at a time or the
printer will be rendered inoperable:
•
System board
•
OP panel UICC card
Replace the required component, bring the printer up in Diagnostics mode (see
page 3-7), and verify that the problem is fixed before performing a POR.
This error code indicates a mismatch between the operator panel assembly and the system board.
Step Questions / actions
1 Has the OP panel UICC card been replaced
recently?
2 Has the system board been replaced
recently?
3 Turn the printer power off for ten or more
seconds. Then turn the printer back on (POR
the printer).
Is the error gone, and can the printer
print?
4 Clear the NVRAM of the printer:
1. Turn the printer power off.
2. With the printer off, press and hold 6, 7
and 8 on the keypad.
3. Turn the printer on.
4. When Restoring Factory Defaults
appears, release the buttons.
Note: If the printer locks up on the
Restoring Factory Defaults, wait two
minutes, and then turn the printer power
off. After ten seconds or more, turn the
printer power back on without holding
down any buttons.
Does the error message still appear?
5 Replace the OP panel UICC card. See
panel UICC card removal" on page
Does the error message still appear?
2-108
Service Manual
Yes
Replace the operator panel
assembly with a new, and
not previously installed,
UICC card. See
UICC card removal" on
page 4-110.
Replace the system board
with a new, and not
previously installed, system
board. See "System
board removal" on
page 4-142.
Problem solved.
Go to step 5.
"OP Replace the system board.
4-110. See "System board
removal" on page
"Diagnostics menu" on
Go to step 2.
"OP panel
Go to step 3.
Go to step 4.
Problem solved.
Problem solved.
4-142.
No