5062
141.xx—Black cartridge motor error service check
Step
Questions / actions
1
Turn the printer off, open the system board
shield, and remove the connector shield.
Check the cable in the connector JKI1 (BLDC
K & ITU cable) for proper connection to the
system board.
Is the cable properly connected?
2
Check the cable in the connector JKI1 (BLDC
K & ITU cable) for damage.
Is the cable damaged?
Measure the resistance across the fuse F10
3
on the system board.
Is the fuse blown?
2-66
Service Manual
Yes
Go to step 2.
Replace the BLDC K ITU
cable. See
"EP drive
assembly removal" on
page
4-54.
Replace the system board.
See
"System board
removal" on page
4-142.
No
Reseat the cable.
Go to step 3.
Go to step 4.