Auto Detect; Print Tests; Print Tests (Input Sources); Print Quality Pages - Lexmark C792e 5062-210 Service Manual

Auto Detect

This test initiates an automatic component detect process. Auto Detect should be used after you replace the
system board.

PRINT TESTS

Print Tests (input sources)

This test determines if the printer can print on media from any of the paper input sources. Each of the installed
sources is available within the Print Tests menu.
The content of the test page varies depending on the media installed in the selected input source.
•
If a source is selected that contains paper, then a page similar to the Quick Test Page is printed and does
not contain the Print Registration diamonds.
•
If a source is selected which contains envelopes, then an Envelope Print Test pattern is printed. This
pattern contains only text, which consists of continuous prints of each character in the selected symbol set.
•
If Continuous is selected, then the same page prints continuously from the selected source until you press
X
Stop ( ). If Continuous is selected from a source which contains envelopes, then the envelope print test
pattern is printed on the first envelope, and the rest are blank.
The Print Test page always prints single-sided, regardless of the Duplex setting or the presence of the Duplex
option.
To run the Print Test:
1.
From the Diagnostics menu, touch PRINT TESTS.
2.
Select the paper source.
3.
Select either Single or Continuous.
Note: If Single is selected, no buttons are active while the Print Test Page is printing. If Continuous is
selected, Stop (
4.
At the end of the test, the printer returns to the PRINT TESTS menu.

Print Quality Pages

The print quality test consists of five pages. Pages one and two contain a mixture of graphics and text. The
remainder of the pages only contain graphics. See
Quality Pages.
This test may be printed from either Configuration menu or the Diagnostics menu. To run the print quality pages
from the Diagnostics menu, select PRINT TESTS and Print Quality Pages from the menu. Once the test is
started it cannot be canceled. After the test pages print, the printer returns to the PRINT TESTS menu.

HARDWARE TESTS

Panel Test

This test verifies the operator panel display function.
To run the Panel Test:
1.
From the Diagnostics menu, navigate to:
HARDWARE TESTS > LCD Test
The Panel test continually executes.
2.
Press Stop (
X
) can be pressed to cancel the test.
X
) to cancel the test.
"Print tests" on appendix page A-1
5062
for samples of the Print
3-13
Diagnostic aids