Exiting The Diagnostics Mode; Dual Diode Adjust - Lexmark X792 Service Manual

7562
Model Name
Configuration ID
Reset Color Cal
Edge to Edge
Cal Ref Adj
Enable Edge to Edge Copy
Par 1 Strobe Adj (if installed)
EP SETUP
EP Defaults
Fuser Temp
DC Charge Adjust
Dev Bias Adj
Transfer Adjust
Op Point Boost
REPORTS
Menu Settings Page
EVENT LOG
Display Log
Print Log
Clear Log
SCANNER TESTS
Scanner Calibration Reset
ASIC Test
Feed Test
Sensor Test
ADF Magnification
EXIT DIAGS

Exiting the Diagnostics mode

Select EXIT DIAGS to exit the Diagnostics mode and return to the printer home screen.

DUAL DIODE ADJUST

Adjust the dual diode alignment before adjusting the Registration or Alignment settings.
1.
From the Diagnostics menu, navigate to:
DUAL DIODE ADJUST > Diode Alignment Page
An alignment page prints.
2.
Follow the instructions on the alignment page and use the touch screen to adjust the dual diode alignment
for Black, Cyan, Magenta, and Yellow.
3.
Reprint the alignment page and adjust the settings as needed.
3-10
Service Manual
See "Model Name" on page
See "Configuration ID" on page
See "Reset Color Calibration" on page
See "Edge to Edge" on page
See "Cal Ref Adj" on page
See "Enable Edge to Edge Copy" on page
See "Par 1 Strobe Adj" on page
See "EP Defaults" on page
See "Fuser Temp" on page
See "DC Charge Adjustment" on page
See "Dev Bias Adj" on page
See "Transfer Adjust" on page
See "Op Point Boost" on page
See "Display Log" on page
See "Print Log" on page
See "Clear Log" on page
See "Scanner Calibration Reset" on page
See "ASIC Test" on page
See "Feed Test" on page
See "Sensor Test" on page
See "ADF Magnification" on page
3-23.
3-23.
3-24.
3-24.
3-24.
3-24.
3-24.
3-24.
3-24.
3-25.
3-25.
3-25.
3-25.
3-25.
3-25.
3-25.
3-26.
3-26.
3-26.
3-26.
3-26.