SERVICE MANUAL
Carefully note the location of the cable and the connection locations of the various plugs.
Either mark each plug and socket, or take a photograph with a digital camera.
In the illustration above, you see the power module (3) and the positions of the optional lighting
circuit board (2), of the optional actuator module (1) and of the optional G-Trac sensor (4).
Pull the plug (1) out of the power module.
Use a 4 mm Allen wrench to loosen both of the hexagon socket head screws (2).
Remove the washers and the black intermediate pieces.
Remove the power module by pulling it backwards from the guides.
Replace the power module.
Refitting the power module:
Refit the parts in reverse order.
Plug all the plugs into their old positions.
Select the drive program as described in chapter 7.4.6.
If a new software version is available, update the drive program as described in chapter 7.5.
54
®
4
Invacare
- STORM
MAX