SERVICE MANUAL
7.18.2.3 Replacing puncture-proof tyres
Requirements:
6 mm Allen key
Two long wooden blocks, min. 14 x 14 x 30 cm
Three joiner's clamps with plastic caps
Torque spanner 5 - 25 Nm (or similar)
Talcum powder
Removing the tyres:
Remove the wheel as described in chapter 7.18.1.
ATTENTION: Explosion hazard!
There is considerable pressure in the tyre. Danger of injury! Parts can be thrown out and
injure you if you do not secure the rim rings.
Secure the rim rings with joiner's clamps.
Secure the rim rings against unexpected discharge with three joiner's clamps. When doing so,
ensure that you do not scratch the rims.
Undo the five 6 mm Allen screws (2) on the inside of the wheel.
Now loosen the joiner's clamps carefully and alternately until you can remove the rim rings
without danger.
Remove the inner (3) and outer (1) ring of the rim from the tyre (4).
Replace any defective or worn parts.
Refitting the tyres:
Refit the tyres to the rim in the reverse sequence.
When fitting the rim rings together, ensure that the drillholes and threads for the bolts are
placed exactly above each other.
Place the joiner's clamps in position.
Tighten the joiner's clamps alternately in small stages until the rim rings are precisely aligned.
Tighten the Allen screws (2) to 18 Nm.
104
®
4
Invacare
- STORM
MAX