L2Tp Vpn Server; Configuring The L2Tp Vpn Server - McAfee SG310 Administration Manual

VPN menu features

L2TP VPN Server

Figure 253 Viewing VPN connection status details
L2TP VPN Server
To set up an L2TP/IPSec connection from a remote Windows XP client to your UTM Firewall appliance and
local network, perform the following procedures:
Enable and configure the L2TP VPN server. See
1
Configure the L2TP IPSec tunnel settings. See
2
an x.509
Set up VPN user accounts on the UTM Firewall appliance and enable the appropriate authentication
3
security. See
Configure the VPN clients at the remote sites. The client does not require special software, since the UTM
4
Firewall L2TP Server supports the standard L2TP and IPSec client software included with Windows XP. See
Configuring the remote L2TP
Note: The L2TP Server does not currently support tunnels with Microsoft clients when there is a device in
between the client and the UTM Firewall appliance performing NAT.
Connect to the remote VPN client. See
5

Configuring the L2TP VPN server

Use this procedure to enable and configure the L2TP server for VPN.
McAfee UTM Firewall 4.0.4 Administration Guide
certificate, and Authenticating tunnels with a preshared
Adding an L2TP user
client.
Configuring the L2TP VPN
L2TP IPSec Configuration
account.
Connecting to the remote VPN
server.
page, Authenticating tunnels with
secret.
client.
251