Dhcp Addresses Page - McAfee SG310 Administration Manual

Network Setup menu options
DHCP Server
Enter the IP address range in the Address Range field. Addresses will be assigned to clients from within
10
this range. Once you enter a range of address on this page, you must manage the addresses from that
point onward in the DHCP Addresses page. For more information, see
Click Finish. The DHCP Server Status page reflects the new configuration and shows the number of used
11
and free addresses. You can now click the edit icon to access the DHCP Addresses page.
Editing a DHCP server configuration
Use this procedure to edit a DHCP Server configuration. If you want to change the Type to DHCP Relay, you
must delete the configuration first. See
From the Network Setup menu, click DHCP Server. The DHCP Server Configuration Status page
1
appears.
Click the edit icon for the Interface DHCP Server configuration you want to edit. The DHCP Addresses page
2
appears for the Interface.
Click the DHCP Configuration tab. The Server Configuration page for the interface appears.
3
Make your changes and click Update. If you want to edit IP address ranges, you must now use the DHCP
4
Address tab. See
Disabling a DHCP server or relay
Use this procedure to disable a DHCP server or relay.
Note: To configure a DHCP relay see
From the Network Setup menu, click DHCP Server. The DHCP Configuration page appears.
1
Clear the enable checkbox for the DHCP server or DHCP relay. The Status column changes from m Used,
2
n Free to Disabled. Once you refresh your browser, the "DHCP Server is Running" message changes to
"DHCP Server is Down".
Re-enabling a DHCP server or relay
Use this procedure to enable a disabled a DHCP server or relay.
Note: To configure a DHCP relay see
From the Network Setup menu, click DHCP Server. The DHCP Configuration page appears.
1
Select the enable checkbox for the disabled DHCP server or DHCP relay. The Status column changes from
2
Disabled to m Used, n Free. Once you refresh your browser, the "DHCP Server is Down" status message
changes to "DHCP Server is Running."
Deleting a DHCP server or relay configuration
Use this procedure to disable a DHCP server or relay.
Note: To configure a DHCP relay see
From the Network Setup menu, click DHCP Server. The DHCP Configuration page appears.
1
Click the delete icon for the DHCP Server or Relay configuration you want to delete. You are prompted to
2
confirm the delete.
Click OK. The Status and Type list display Not Configured.
3

DHCP Addresses page

This page becomes available after an interface has been configured as a DHCP server. See
Note:
Configuring a DHCP server
Use this page to view the status of IP addresses. You can also free leased addresses; and add, reserve, and
delete addresses.
126 McAfee UTM Firewall 4.0.4 Administration Guide
Deleting a DHCP server or relay
DHCP Addresses page.
Configuring a DHCP
Configuring a DHCP
Configuring a DHCP
.
DHCP Addresses
configuration.
relay.
relay.
relay.
page.