Dns - McAfee SG310 Administration Manual

Network Setup menu options

DNS

#password changeme
#enable password changeme
In bgpd.conf, enter:
hostname sg
! Uncomment and set telnet/vty passwords to enable telnet access on port 2605
#password changeme
#enable password changeme
! Access list, used to limit the redistribution to private networks (RFC 1918)
access-list local_nets permit 192.168.0.0/16
access-list local_nets permit 172.16.0.0/12
access-list local_nets permit 10.0.0.0/8
access-list local_nets deny any
! Our AS number
router bgp 1
! Our IP address
bgp router-id 192.168.0.1
! Announce our own network to other neighbors
network 192.168.0.0/24
! Advertise all connected routes (directly attached interfaces) redistribute connected
! Advertise kernel routes (manually inserted routes, IPsec)
redistribute kernel
! Every 'router bgp' block contains a list of neighbors to which the router is
connected:
neighbor 192.168.1.1 remote-as 2
neighbor 192.168.1.1 distribute-list local_nets in
neighbor 10.10.1.1
neighbor 10.10.1.1
Restart route management to enable the updated configuration – clear the Enable route management
checkbox, click Update, select the Enable route management checkbox again and click Update.
If you prefer, you can uncomment the password and enable password lines, and then telnet to the
relevant ports to configure Zebra and/or ospfd via the command line. The command line interface is very
similar to the Cisco IOS interface. If you are familiar with this, you may prefer to configure using this
method.
DNS
The DNS (Domain Name System) is a service that translates, or maps, host names to IP addresses. DNS
also maps from IP address numbers to the machine name, which is referred to as reverse mapping. The
DNS settings control the network name services of the UTM Firewall appliance. The DNS tab contains the
following tabs:
• DNS Proxy tab
• Dynamic DNS tab
McAfee UTM Firewall 4.0.4 Administration Guide
remote-as 3
distribute-list local_nets in
117