Configuring Usb Port Settings - McAfee SG310 Administration Manual

Network Setup menu options
3G USB Modems
[Conditional; if you are creating a 3G connection] Enter the Access Point Name for the connection.
c
You can get this from your ISP.
Enter the DNS Server address given to you by your ISP. You can enter multiple DNS servers into this
d
field by separating them with commas.
Enter the Phone Number to Dial to reach your ISP. You can enter more than one phone number by
e
separating them with commas.
[Conditional} If your ISP requires a specific authentication method to connect, select the method from
f
the Authentication Method drop-down list.
Select an Encryption Level from the drop-down list.
g
[Optional] If the remote network has a Windows domain server, you might need to specify it to
5
authenticate. Enter the domain in the Domain field.
[Conditional; if required]] Enter the username allocated by the ISP provider in the Username field.
6
[Conditional; if required]] Enter the password provided by your ISP in the Password field. Enter the
7
password again in the Confirm Password field.
[Conditional; if required]] Enter the SIM card PIN code for your GPRS or 3G connection.
8
[Optional] Select a Firewall Class for the connection. The firewall class determines the packet filtering
9
rules that are applied to the connection. See
[Optional; if the connection has a firewall class of Internet] If you want the connection to serve as a
10
default gateway, select the Preferred Gateway checkbox. If more than one preferred gateway is active
on the device, traffic is load-balanced across the preferred gateway connections. See
balancing, and high availability.
Click Finish.
11

Configuring USB port settings

Use this procedure to configure USB port settings.
Caution: USB port settings should only be modified with the assistance of Technical Support personnel.
You can set the serial port Baud rate and Flow Control, but this is not usually necessary.
From the Network Setup menu, click Network Setup. The Connections tab opens. Click the edit icon
1
for the Unconfigured USB connection.
Click the Port Settings tab. The Serial Port Setup page appears
2
Figure 107 Port Settings-Serial Port Setup
Select the type of flow control to perform from the Flow Control list. Available options are:
3
McAfee UTM Firewall 4.0.4 Administration Guide
Packet filtering.
(Figure
Failover, load
107).
107