Confirming Settings; Setting Up The Pcs On Your Lan - McAfee SG310 Administration Manual

Getting Started

Confirming settings

Confirming settings
Review your configuration selections. If you are satisfied with your settings, click Finish to activate the
new configuration
Figure 25 Quick Setup Wizard – Confirmation dialog
.
Note: If you changed the UTM Firewall's LAN connection settings, you may not be able to contact it at this point.
The following describes how to set up the PCs on your network to access the device and the Internet.
If you have not already done so, connect the device to your LAN:
• If you are setting up the SG310, connect PCs and/or your LAN hub directly to its LAN switch.
• If you are setting up the SG560, SG560U, SG565 or SG580 and have configured its switch as 4 LAN
Ports, connect PCs and/or your LAN hub directly to switch A.
• If you are setting up the SG560, SG560U, SG565 or SG580 and have configured its switch as 1 LAN
Port, 3 Isolated Ports, connect port A1 directly to your LAN hub.
• Otherwise, connect the LAN port directly to your LAN hub.

Setting up the PCs on your LAN

Each PC on your LAN must now be assigned an appropriate IP address, and have the UTM Firewall's LAN IP
address designated as its gateway and DNS server. A DHCP server allows PCs to automatically obtain these
network settings when they start up. If your network does not have a DHCP server, you may either
manually set up each PC on your network, or set up the UTM Firewall's DHCP server.
• [Recommended] To use the UTM Firewall's built-in DHCP server, proceed to
using an existing DHCP
• If your LAN already has a DHCP server you will use instead of the UTM Firewall's built-in DHCP server,
proceed to
McAfee UTM Firewall 4.0.4 Administration Guide
(Figure 25).
server.
Automatic LAN configuration using an existing DHCP
Automatic LAN configuration
server.
31