Detected Usb Devices; Packet Capture Page - McAfee SG310 Administration Manual

System menu features
Diagnostics menu
From the System menu, click Diagnostics > Network Tests tab. The Network Tests page appears.
1
Enter the IP Address of the box you want to trace packet routing for in the IP Address of Remote
2
Machine field.
[Optional] Select an interface from the Source Interface list.
3
• Default: None.
[Optional] To perform a reverse DNS names lookup on IP addresses, select the Lookup DNS Names
4
checkbox.
Click Traceroute. The results of the test are displayed
5
Figure 375 Trace route results

Detected USB Devices

Use this tab to display the current Universal Serial Bus devices plugged in and detected by the appliance.
Note: USB is available on the SG565 model only.
For more information about USB devices, see
From the System menu, click Diagnostics > USB tab. The USB Devices page appears
Figure 376 USB Detected Devices
The Vendor, Product and ID details are obtained by querying the devices directly. The ID field is a
combination of the Product ID, Vendor ID, and Serial Number. If this is missing, or the same as any
other devices, then configuring and using the device may be unreliable.
The Driver field shows the driver module loaded to utilize the USB device. If this is listed as (None), then
the appropriate sub-system may not be currently enabled or the driver may need to be manually loaded.
Refer to the Technical Support Knowledge Base for a list of what devices are supported, and how to
manually load drivers for devices that are not automatically detected.

Packet Capture page

You can capture network traffic in a packet capture (pcap) file. Packet captures are saved to n.pcap files in
the /var/tmp directory. You can either download or decode the .pcap file. This can be useful for diagnosing
network problems. The downloaded file can also be viewed using freely available utilities such as tcpdump
or Wireshark.
McAfee UTM Firewall 4.0.4 Administration Guide
(Figure 375).
Appendix A, .
(Figure 376).
361