Adding A Port-Based Vlan - McAfee SG310 Administration Manual

Network Setup menu options
VLAN
Figure 102 Ethernet Configuration—Configure Ethernet Port page
Select the Enable port-based VLANs checkbox.
4
As the default VLAN is always untagged, typically you only need to change the Default port-based
5
VLAN ID from the default setting of 2 if you want another port to participate on an existing tagged VLAN
with the ID of 2.
• Default: 2
• Range: 1-4094
Click Update.
6

Adding a port-based VLAN

Use this procedure to manually add a port-based VLAN on the switch of a UTM Firewall appliance.
Tip: If you previously selected the 1 LAN Port, 3 Isolated Ports option in the Switch Configuration step of
the Quick Setup Wizard, a single isolated VLAN for each port on the switch has already been added as shown in
Figure 103. You can also run the wizard again to select this feature, skipping the options that are already
configured. To relaunch the wizard, click Quick Setup in the Network Setup menu. All that remains to do with
the wizard approach is configuring the Mode and connection (Change Type) for each port.
102 McAfee UTM Firewall 4.0.4 Administration Guide