Advanced Settings - Xerox ApeosPort-II 5010 User Manual

16 Appendix

Advanced Settings

Auto Layout
Active Palette
No. of Prints
Output Tray
Two-Sided
Printing
16
Chinese Fonts
Alphanumeric
Fonts
Vertical Position
Adjustment
Horizontal
Position
Adjustment
568
106 0 (Default): ON
1: OFF
Selects whether aligning the position of the document and the paper is to
be done automatically or not.
107 0 (Default): Command
1: Panel
Selects whether to use a pen specified by command or set on the panel.
108 1 250 (Default): 1): 1 - 250
-
Sets the number of prints to be made.
109 0 (Default): Center Output Tray
1: Side Tray
80: Finisher Tray
Sets the output tray.
110 0 (Default): None
1: Head to head
2: Head to toe
Sets the two-sided printing.
[None]...Prints one side.
[Head to Head]...Place the paper as in the [Paper Orientation], and it
prints both sides so that the orientation of the up-sides are aligned for
each page when the left side is closed.
[Head to Toe]...Place the paper as in the [Paper Orientation], and it prints
both sides so that the orientation of the up-sides are aligned for each
page when the top side is closed.
111 0: Stroke
Specifies 2-byte character fonts, including Chinese characters. The
setting cannot be changed for this model.
112 0: Stroke
Specifies 1-byte character fonts. The setting cannot be changed for this
model.
113 0 (Default): Does not move the hard clip area.
1 to 500: -250 to +250 mm
Moves the hard clip area vertically.
-1 -250 mm for setting numbers 1
to
+1 +250 mm for setting numbers 251
to
114 0 (Default): Does not move the hard clip area.
1 to 500: -250 to +250mm
Moves the hard clip area horizontally.
-1 to -250 mm for setting numbers 1
+1 to +250 mm for setting numbers 251
250
-
500
-
250
-
500
-